Conta-clip EMS-eco-Plotter-System Bedienungsanleitung

©EMS - ecoOperating InstructionsRelease: July 21, 2010 1EMS - ecoEasy-Marking-System

6. Cleaning and product careProtect the EMS-eco from dust and other dirt. When not in use, cover the plotter. A special dust cover is available as an

7. AccessoriesRefill-Plotter PenInk CartridgesDisposable-Plotter Penavailable in six tip-widthsavailable in six tip-widthsCleaning SetPen Cleaner Clea

8. TroubleshootingIf your plotter EMS-eco is not functioning correctly, please check the following:Device fails to switch on Check whether the mains p

9. Technical InformationEMS-eco plotter specificationsType of plotter: Flatbed plotterMaximum plotting area: 220 mm x 305 mmPlotting speed with pen: M

10. Instructions for packaging the plotter EMS - ecotwo corner pieceswith inlaytwo corner pieceswithout inlaycenter piece coveringthe y-arminside the

11. Safety instructionsSafety instructions●Keep the operating instructions in a safe place.●This device complies with all recognised technical standar

Instructions de sécurité●Conserver ces instructions dans un endroit sûr.●Cet appareil répond aux normes techniques et satisfait toutes les règles de s

1. Introduction...32. Items supplied ...

1. Introduction:Thank you for purchasing the EMS-eco, a flexible plotter that helps you label markingelements quickly and easily.Rugged construction i

2. Items suppliedPlease check you have received all the items supplied with your labelling device(see list below).Please retain the packaging in case

3. Product overview1) Plotting area2) Pins for holding support plates3) Clip adapter for plotter pen4) Penholder5) Power supply6) USB port7) Control p

4. Setting up the Plotter EMS - ecoLOCATIONA dry, dust-free room is the ideal environment for the plotter. If possible, do not installthe device in da

5. OperationOnce you have installed the EMS-eco and connected the power supply and datacable, you can switch the plotter on.Important:Before switching

Stop/view keyIf the 'stop/view' key is activated while the plotter is in action, the job will pauseimmediately and the plotter pen will move

Placing the fixtures on the Plotter EMS-ecoThere are four pin stops on the plotting area where up to two different fixtures can beloaded. Different fi